The Sikadur®– Combiflex® SG System is a high performance joint sealing system for construction, expansion and connection joints as well as for cracks. Sika® ‘White Tank’ System and refurbishment with the. Sika® -1 Prebagged System. Sikadur® Combiflex® tested under high water-pressure. In conjuction with. The Sikadur®-Combiflex® SG System consists of a flexible Polyolefin (FPO) . Sika® System test: Sikadur®-Combiflex® SG Tapes bonded to each other with.
|Published (Last):||18 July 2004|
|PDF File Size:||14.19 Mb|
|ePub File Size:||10.4 Mb|
|Price:||Free* [*Free Regsitration Required]|
These quantities do not allow for waste or undulations in the substrate. In practice, the differences in materials, substrates and actual site conditions are such that no warranty in respect of merchantability or of fitness for xika particular purpose, nor any liability arising out of any legal relationship whatsoever, can be inferred either from this information, or from any written recommendations, or from any other advice offered.
On comviflex other hand, joints in pedestrian areas should be flush with the The optimal ratio of joint width to depth seal- surface to prevent injury of people.
SIKA >4 Inch Combiflex – Joint Tape, Usage: Sealing, Rs /roll | ID:
Wash hands immediately after use. Do not thin Sikadur 31 with solvents.
The than common floor joint sealants. Click here to sign up. Hypalon Welding Solvent should be liberally applied to both sides of the lap.
It is typically used for sealing or re-sealing joints in: Sika supports you in determining a fitting solution that meets all requirements, has all mandatory approvals and the expected lifetime. Long-lasting Sika sealants ensure the tightness of the generator housings even under severe weather conditions on sea and seal the joints in concrete segment columns to prevent water penetration and consequent frost damage.
In addition sealants have to fulfil specific There are a great number of international, re- guidelines depending on their application. This full range approach ensures reliable and long lasting technical solutions for a long life ex- pectancy of the building or structure. This durable solution reduces down 2 Compression profile times of sewage treatment plants. Remove uncured Sikadur 31 from tools with Kwiklean water soluble solvent immediately after use. Place the activated Combiflex Hypalon Sheeting over the joint with the red preapplied masking strip facing up and roll it into the Sikadur 31 until the epoxy adhesive comes through the perimeter holes.
Hence, the maintenance costs are lower thus reduces maintenance costs as well. Our sealants and accessory products are generally designed to ultimately save mon- Why Elastic Sealing?
Skip to main content. Especially in areas frequented ant is surprisingly simple.
Sikadur Combiflex SG 20cm x 25M – Sealants Direct
Wash clothing before re-use. Wash thoroughly with soap and water. Sikadur-Combiflex is designed to be applied to a wide variety of substrates on either side of high movement and irregular joints or where the use of conventional sealing techniques is not possible. To store the biological waste, tight silos and containers are needed. Only sealants specifically designed for waste water treatment chemicals this environment are suitable.
Approximately 3 – 4 linear meters per litre.
Sikadur Combiflex® SG
Colma Cleaner and Hypalon Welding Solvent. An old sealant needs to be renovated at the sealant with similar dimensions as the original end of a normal life cycle or because of main- joint or a sealant with similar mechanical Reasons for joint refurbishment may include tenance or quality insufficiency reasons. Use of an approved dust respirator, safety goggles and chemical resistant gloves are recommended.
Open time 1mm film. Hence, the emergency services gain time to pump the aggressive chemicals into secure containers and the risk to contami- nate ground or drinking water is significantly combif,ex. The main requirements for a joint sealant in The main advantages for these coombiflex of flexi- The main requirements for a joint sealant in swimming pools are: Perforations in membrane reduce air entrapment. Help Center Find new research papers in: In order to ensure long term durability and tightness of the newly sealed joint both the substrate surfaces as well as the old sealant remains should be pretreated using the prim- er recommended by Sika.
Only mix sufficient sioa that can be readily used within its pot life. Tear Strength between sheeting and Sikadur 31 sheeting width: Sika provides different tailor-made solutions for drinking water storage and waste water treatment including sealants, coatings and waterproofing systems. Cured Combilex 31 is a vapour barrier. In damp conditions use a chalk mark. In Minimum joint width mm 12 12 12 12 12 12 order to obtain a long-term optimal perfor- Sealant thickness mm 12 12 12 12 12 12 mance the following considerations are es- Exterior Floor Joints sential as well: Cured material xika only be removed mechanically.
Use cover plates over joints in traffic areas. Water retaining structures Roofs Parking structures Basements Iron, steel and concrete pipes Between rigid and flexible surfaces Canals.
The application machines passing over The excellent mechanical properties allow is quick and efficient. The product is substrate surface must be clean, dry and free used to activate non-porous substrates such from any grease, oil, dust, release agents and as metals, plastics, glazed ceramics and various any other substances that potentially could combuflex painted surfaces.